Airlive WL-5480USB-80 Bedienungsanleitung

1 WL-5480USBWireless USB Adapter User’s Manual

10 Step 1 Select the SSID of your wireless router/access point from the Available Network list and click on the Connect this site button. Step 2 V

11 Current Network Information: Displays the network information of the wireless router/access point that the USB adapter is currently connected t

12 3.1 Configuring General Settings Click Change to configure the adapter’s General Connection Setting. Channel: This setting is for Access Point

13 3.2 Configuring Encryption Security Click WEP Encryption Key Setting to configure the WEP settings. Click Change to configure the WEP Key Set

14 Key Value: Enter the applicable key values. Up to four key values may be entered. Note the following rules when entering Key values: ‧ 64-bit

15 1. Select TKIP for Encryption, WPA PSK for Authentication Mode, and click Apply. 2. Click on WPA Encryption Setting and click Change. 3. Ente

16 3.3 Configuring Profile After you have configured all the settings, you can save your settings as a profile so you don’t have to re-configure

17 To load a profile, select the profile from the drop-down menu and click Load. To delete a profile, select the profile from the drop-down menu an

18 Power Consumption Setting: • Continuous Access Mode: provides the best signal throughput but least power save. • Maximum Power-Saving Mode: pr

19

2 Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of FC

20 4. Configuring USB Adapter as an Access Point 4.1 Configuring Access Point You can configure the USB Adapter as an access point for other wireles

21 Click on Change to configure the settings. Channel: select the channel you want to use. Basic Rate: select the applicable transfer rate. S

22 4.2 Configuring Encryption Security Select Enable from the WEP drop-down menu and click Setting. Key Length: Select the appropriate encryptio

23 4.3 Configuring MAC Address Filter Filter Type: Disable: disables MAC address filter. Accept: only accepts connection from the MAC address

24 5. Appendix 5.1 Specifications Electrical Specifications Interface USB 2.0 Standard, USB 1.1 Compliant Standards Conformance IEEE802.11 / 802.11b

25 5.2 Troubleshooting A. If the utility cannot be opened or it reports that the adapter is not found, uninstall the driver and utility and try in

26 For Windows 98SE/ME Step 1 Go to Start, Run, type winipcfg and click OK. Step 2 Select the adapter from the drop-down menu and click Release.

27 5.3 Frequently Asked Question 1. What is the IEEE 802.11g standard? The IEEE 802.11g Wireless LAN standard subcommittee which formulates the st

3 1. Introduction The AirLive WL-5480USB (hereafter called USB adapter), compliant with IEEE 802.11b/g, is a high-efficiency wireless adapter for wir

4 2. Installation Procedures 2.1 Install Utility Software Note1: Before installing the utility software, DO NOT insert the USB adapter into your co

5 Step 4 Click Next to accept the default destination folder for the software or click Browse to manually select a different destination folder.

6 For Windows 2000, click Yes at the Digital Signature screen. Step 6 Remove the Driver & Utility CD from your CD drive and then restart y

7 Note: In most cases, Windows will automatically install the driver after the computer is restarted. If the Found New Hardware Wizard appears, follo

8 For Windows 98SE or ME, insert the Windows 98SE or ME CD if prompted to do so and click OK. Step 4 Click Finish. Restart the computer if you are

9 3. Configuring USB Adapter as a Wireless Client The USB adapter can be set to either Station or Access Point Mode from the Mode drop-down menu. Sta